The following coax routing arrangement has been trouble free for over
three years at this and other installations.
Position the ant. so it is pointed North (assuming you are using
North centered rotation), then route the coax over one of the
horizontal braces nearest the antenna, if bringing the coax up the
tower's inside, or tie it off, if running the coax on the outside of
the tower, 4 to 5 feet above the TIC Ring. Loop down to about 4
inches above the TIC ring and back up to the top of the boom guys
support. Continue routing the cable down the boom guys support to
the boom, etc. Check to insure you have enough loop for 180 degree
rotation in either direction.
Good luck with the installation.
> >2) What's the best way to route cable when using a Tic
> >Ring? FYI. the rings are just above guy attachment
> >points.
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
73,
Mike, K4GMH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|