Why not fix the coax well above the Tic Ring, do the rotator loop there and
then clamp the cable down the guy support of the beam?
73
Peter
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Hardy Landskov
>2) What's the best way to route cable when using a Tic Ring? FYI. the
>rings are just above guy attachment points.
>
This has been a tough one for me. The worst possible arrangement. The coax
will hang up on the guy wires; and if too close will get into the Tic Ring.
I had both happen. It generally takes a precise length of coax so that
neither happens. You have to experiment.
GL N7RT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|