Maybe you could use strips of aluminum flashing riveted together.
There is always anti-oxidant grease used for copper to aluminum connections.
Mark N1UK G3ZZM
----- Original Message -----
From: <Cqtestk4xs@aol.com>
To: <TOWERTALK@contesting.com>
Sent: Wednesday, 12 September, 2007 12:27 PM
Subject: Re: [TowerTalk] attaching #4 bare to aluminum tower legs
> In order to stop oxidation at the tower legs on the aluminum, I made a
> "sandwich" of stainless steel between the leg and the copper. I used a
> piece of
> stainless hose clamp for it.
>
> Instead of copper wire, I used an old piece of 1/2 Heliax and pounded it
> flat for the ground wire. It surely was a lot cheaper, and gave a larger
> surface to "bond" to the tower. Also, I believe the flat surface area is
> more
> conductive for lightning due to the increased surface area.
>
> I intend to due the same thing out here in KH6 on my new tower
>
> Bill K4XS/KH7XS
>
>
>
> ************************************** See what's new at
> http://www.aol.com
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|