Hello all:
I have an installed Tashjian tower, which I guess used to be Tri-Ex. It is
a 70 ft 4 section nesting tower.
I have purchased a Hy-Gain Tailtwister II rotator which--OOPS!-- looks as
though it might be too wide to get into the #6 section, the inner, highest,
section of the tower. #6 is Tashjian's designation, might have been Tri-Ex
designation also, I don't know.
Does anyone have knowledge about whether or not I can use the TT II with
this tower?
The rotator shelf (uninstalled at this point) which Karl Tashjian supplied
me for the #6 section does fit the TT II perfectly, predrilled holes and
cable cutout fit perfectly.
If no-one on the reflector knows, I will phone Hy-Gain and Tashjian
tomorrow.
Thanks,
Rusty, na5tr
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|