Dave, I will send you my data as promised , but KK9A is correct about the
point to point wiring.
By the way, the Telrex rotator runs 110v to the tower for the rotator and
the selsyn. I have a BA2345RIHS 2-inch rotator (with an internal heater in
the metal box) and Telrex recommends size 18 wire for terminals 1,
9,10,11,and 12; size 12 for terminals 2,3, and 4; and size 14 for terminals
5,6,7 and 8. My manual for the 3-inch rotator has the same wiring
requirements. It just occurred to me that the rotator has NO fuse. I am
going to install a fuse on each leg of the incoming AC. My motor shows
current requirements of 4.5/2.5 amps so I will first try some 5 amp
slo-blows and see what happens. 73 Saul K2XA
----- Original Message -----
From: <john@kk9a.com>
To: <TOWERTALK@contesting.com>
Cc: <w5kow5ko@yahoo.com>
Sent: Saturday, August 04, 2007 8:10 PM
Subject: [TowerTalk] rotor
>I have a Telrex rotator and I also do not have a wiring diagram. I don't
> recall having any difficulty wiring it up. Doesn't it have a numbered
> terminal strip on both the control box and rotator where you can hook up
> terminal 1 to terminal 1, 2 to 2, 3 to 3, etc?
>
> KK9A.
>
>
>
> To: towertalk@contesting.com
> Subject: [TowerTalk] rotor
> From: dave streight
> Date: Fri, 3 Aug 2007 18:54:56 -0700 (PDT)
> List-post: <mailto:towertalk@contesting.com>
>
> i have a telrex rotor i need info. on. it it is a model# A1312RISX .
> need
> the wire digram
> it has two selsyn motors one in the control box and one at the rotor . i
> cant
> find any info any
> where maybe some one can help thanks dave w5ko
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|