Alan and Frank,
Thanks for the info.
These will be quite helpful!
Vy 73,
Gordon Beattie, W2TTT
201.314.6964
-------------- Original message from "Alan Burgstahler" <alan-ham@comcast.net>:
--------------
> 1. Wrenches and a soldering iron for removing the center pin.
> 2. If you deem it necessary, Andrew sells kits for reinstalling the
> connectors that have a new center pin and the rubber pieces. You may be
> able to reuse them, depending on how you feel and how it looks after you
> remove them. I've reinstalled them for ham use and been pretty successful
> without the the kits.
> 3. (Don't know)
> 4. Standard N connectors: http://www.andrew.com/search/BN_237467.aspx
> I've seen UHF connectors for LDF4-50 but can't find any reference to any
> at this time.
>
> Alan - N7BF
>
> ----- Original Message -----
> From:
> To:
> Sent: Sunday, July 08, 2007 1:08 PM
> Subject: [TowerTalk] LDF4-50 & FSJ4-50 Connector Reuse
>
>
> >I have a nice quantity of each of these Andrew cables and a number of
> >really short jumper cables that I would like to us as source material for
> >connectors that could be used on the longer lengths of hardline.
> > My questions are:
> > 1. Is there anything special that I should consider when removing the
> > connectors?
> > 2. Is there anything that I need to replace when recycling the connectors?
> > 3. Differences in the handling (other than flex) between the LDF4-50 and
> > the FSJ4-50?
> > 4. Does anyone have a pointer to a step-by-step process for installing N
> > and UHF connectors (male and female) on these cables?
> > Thanks &73,
> > Gordon, W2TTT
> > 201.314.6964
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|