Gordon,
Here are two useful Andrew Heliax connector installation instructions:
http://www.avw.co.nz/images/Andrew/LDF4-connectorattach.pdf
http://www.andrew.com/search/BN_50423.aspx
You can purchase replacement parts from RF Connection in Gaithersburg, MD. The
most common parts needing replacement in a used connector are
the soldered pin (in the older style connectors) and the gaskets.
73!
Frank
W3LPL
---- Original message ----
>Date: Sun, 08 Jul 2007 20:08:34 +0000
>From: w2ttt@att.net
>Subject: [TowerTalk] LDF4-50 & FSJ4-50 Connector Reuse
>To: towertalk@contesting.com
>
>I have a nice quantity of each of these Andrew cables and a number of really
>short jumper cables that I would like to us as source material for connectors
>that could be used on the longer lengths of hardline.
>My questions are:
>1. Is there anything special that I should consider when removing the
>connectors?
>2. Is there anything that I need to replace when recycling the connectors?
>3. Differences in the handling (other than flex) between the LDF4-50 and the
>FSJ4-50?
>4. Does anyone have a pointer to a step-by-step process for installing N and
>UHF connectors (male and female) on these cables?
>Thanks &73,
>Gordon, W2TTT
>201.314.6964
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|