Gordon, they are 1819s or 1820s. However, another past post suggested
using 28 volt LEDs. I bought them and they work well. They fit directly
in the original socket. I am also using them for the meter lights in my
Titan amps. I don't have the supplier's name here at this time, because
I'm away from home. Maybe someone else can provide it.
73, Joe
K2XX
J. Gordon Beattie, Jr., W2TTT wrote:
> OK, now the question is: what's the spec on the light bulbs used in Ham III
> and IV controllers and where do you get them? Waaaaaaay back when, I bought
> them at Radio Shack and many local places that don't exist anyone.
> 73,
> Gordon, W2TTT
> 201.314.6964
> W2ttt@att.net
>
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of kd4e
> Sent: Friday, June 29, 2007 9:30 PM
> To: TowerTalk@contesting.com
> Subject: [TowerTalk] Polarized Electrolytic in Rotator Box?
>
> May I use a 108-130UF 250VAC polarized electrolytic
> starting capacitor from ACE hardware to replace the
> bad one in my CDE/HamII rotator control box?
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|