Towertalk
[Top] [All Lists]

[TowerTalk] Tower design question

To: towertalk@contesting.com
Subject: [TowerTalk] Tower design question
From: Tom Antil <THANT1L@NETSCAPE.COM>
Date: Sat, 30 Jun 2007 05:49:36 -0400
List-post: <mailto:towertalk@contesting.com>
Something has been bothering me for a while. With all the discussion and 
problems with tower leg corrosion, filling with water and splitting, etc. Why 
do almost ALL the manufacturers design the joints to telescope inside from 
above which leaves water able to run inside joints and fill tubes? Why not 
simply invert the connection by telescoping over the bottom section so water 
just runs outside not through the joint. I know there is no difference in joint 
strength or assembly difficulty, so why?
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



One word describes this:   *Booboise.   *
Pronounced *= boob was see.
  definition= * that segment in society made up entirely of  *Boobs *and 
*Idiots.* Tom Antil   ab1gf
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>