Something has been bothering me for a while. With all the discussion and
problems with tower leg corrosion, filling with water and splitting, etc. Why
do almost ALL the manufacturers design the joints to telescope inside from
above which leaves water able to run inside joints and fill tubes? Why not
simply invert the connection by telescoping over the bottom section so water
just runs outside not through the joint. I know there is no difference in joint
strength or assembly difficulty, so why?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|