Bill, the answer to your question is in Chapter 5 of the ARRL 20th edition
of the ARRL Antenna Book. The nonmagnetic shield is "to maintain loop
balance with respect to ground, by forcing the capacitance between all
portions of the loop and ground to be identical". By maintaining the
electrical loop balance is to eliminate what is referred to as the antenna
effect. You can read on and learn a lot. Sometimes theory works when you
put it to a practical use, sometimes it doesn't. I am just want a good loop
antenna and I am sure someone has tried it and I want to know of their
experience and results. Fred
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Bill Turner
Sent: Tuesday, April 24, 2007 2:28 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Large Loop Antenna - Electrostatically Shield Loops
ORIGINAL MESSAGE:
On Tue, 24 Apr 2007 12:32:48 -0400, KC1DI <davekc1di@gmail.com> wrote:
>
>Well I've used Electrostatically Shielded loops in the past but they
>have always been for Receive only.
------------ REPLY FOLLOWS ------------
Changing the subject slightly, what is it exactly you are shielding
the loop from? I have heard of electrostatically shielded loops but
never quite understood the need for shielding. Can you explain?
Thanks,
Bill W6WRT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|