This is where digital camera's shine so to speak and you in some cases shoot
a detailed movie of all the part's and location.
Just be sure to block and chain all the sections so they
cannot move and above all else be very careful. 73 Gene K2QWD
Subject: Re: [TowerTalk] US Tower HDX-555
Just pull the new cables in while pulling the old cables out. You're lucky,
using pre made cable sets. Try it when making up your own cables.
Bob W6TR
----- Original Message -----
From: "Phil Snyder" <n9lah@comcast.net>
To: <towertalk@contesting.com>
Sent: Sunday, April 08, 2007 5:08 PM
Subject: [TowerTalk] US Tower HDX-555
> OK I have gotten the replacement cables from US Towers. Any tips from
> the folks who have done this project yet? The short cable for the upper
> section seems pretty straight forward. It is the routing of the cable
> through the motor drive that concerns me a little. I do plan on taking
> lots of pictures before and during the process. I also have access to
> two other units to check things out but both the closest is 30-40
> minutes away.
>
> Thanks
> Phil
> N9LAH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|