Just pull the new cables in while pulling the old cables out. You're lucky,
using pre made cable sets. Try it when making up your own cables.
Bob W6TR
----- Original Message -----
From: "Phil Snyder" <n9lah@comcast.net>
To: <towertalk@contesting.com>
Sent: Sunday, April 08, 2007 5:08 PM
Subject: [TowerTalk] US Tower HDX-555
> OK I have gotten the replacement cables from US Towers. Any tips from
> the folks who have done this project yet? The short cable for the upper
> section seems pretty straight forward. It is the routing of the cable
> through the motor drive that concerns me a little. I do plan on taking
> lots of pictures before and during the process. I also have access to
> two other units to check things out but both the closest is 30-40
> minutes away.
>
> Thanks
> Phil
> N9LAH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|