Hello Towertalkians,
This is a question for those of you who rebuild your own Hy-Gain rotators.
I am in the process of rebuilding a T2X. It appears that the motor shaft has
excessive vertical play, which is allowing the bottom of brass pinion on the
motor to catch on the third spur gear. I assume the top of motor shaft is
supposed to have some type of retaining ring to keep the shaft from dropping
down inside the motor. Can anyone tell me what type of retaining ring this is?
It is not listed or shown on the parts diagram, since it is a sub-part of the
motor assembly. Hopefully I can find a suitable substitute at the local
hardware store. The motor assembly is $70.00!
Thanks in advance.
73 de Bill
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|