I would try filling the tubing with sand and manually straightening it. You
did not say how bad the bend is. If the element is kinked it is not possible
to straighten it. 73, Dan, N5AR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Robert Thain
Sent: Monday, October 09, 2006 2:02 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Redressing / straightening aluminium elements.
Hello,
I've just checked the archives and was surprised not to find any info on
this topic (Its happened to us all, right ?) .....
I have acquired a Hygain beam, which took a tumble (that is why I have it).
Quite a few of the elements are bent,
mainly the tips where they join the next section.
What is a good way to redress them.
I do not think 'just bending them back in the other direction' is a possible
solution. Because I am sure they would not bend in the correct place and it
could also snap them due repeated bending in the same place.
Would heating them, help (to make the metal softer ?)
Your comments are most welcome.
Thanks
Robert g0hgw(at)yahoo.com (at) = @
___________________________________________________________
The all-new Yahoo! Mail goes wherever you go - free your email address from
your Internet provider. http://uk.docs.yahoo.com/nowyoucan.html
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.407 / Virus Database: 268.13.1/466 - Release Date: 10/7/2006
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|