It's something like 2-1/2 (or 3) by 2-1/2 (or 3) by 4' deep. That's my
recollection.
But you really should have the Rohn spec. book in front of you. That's the
authority on questions like this.
I think championradio.com has them available, as I've seen K7LXC (moderator of
this reflector) mention before.
73 - Rich, KE3Q
----- Original Message -----
From: JIM BARRON<mailto:WB5AAA@ALLTEL.NET>
To: towertalk@contesting.com<mailto:towertalk@contesting.com>
Sent: Tuesday, April 25, 2006 11:49 AM
Subject: [TowerTalk] Rohn 45 Base
Well Folks,
How big do I need to dig the hole for a ROHN 45 going up about 80'?
I plan on using a section of tower in the cement then put 7 or 8 sections of
tower on top of the base section
thanks for any help
73 for the shack of wb5aaa
Jim Barron
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com<mailto:TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk<http://lists.contesting.com/mailman/listinfo/towertalk>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|