The Rohn 25 house bracket works perfectly for this tower. All you need
is to fabricate a steel strap to hold the tower to the bracket with
bolts. I did this for my TT-40. The tower was up 20+ years. Never a
problem.
73,
dave
wa3gin
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Jim Jarvis
Sent: Monday, August 29, 2005 6:48 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] TT40 Wilson Tower
House bracketed bearing? You COULD fabricate a block
from oak, and grease it. Then captivate it in a steel
bracket which bolts to the building. If you were to do
so, look for Fernco rubber plumbing couplings, to place above
and below the block, to keep water out, and grease in.
On the other hand, if you pour enough concrete to start with,
you shouldn't need the house bracket.
N2EA
jimjarvis@ieee.org
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
any questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|