I will probably get beat up on this but what I have is a 6'x3"x1/4"
aluminum bar behind my operating position. It is drilled and tapped
every 6". Then at the end I have a 1/4 x 20 bolt that I attached my
large ground braid that goes about 5 feet to my ground rod system.
Have not had problems with ground loops etc.
Dick W7ZR
On Fri, 14 Jan 2005 13:39:05 -0800 (PST), N6KJ <n6kj@yahoo.com> wrote:
> How do people attach their rigs to a bus-bar (or
> similar)? The bigger the ground wire the better, but
> most rigs/amps have small, somewhat fragile grounding
> posts. How do others out there connect a nice
> hefty ground wire to their rig or amp? Also, how
> do people attach the wires to the bus-bar or
> ground rod? Bolts? U-Clamps? Solder? Any
> advice would be appreciated.
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - Helps protect you from nasty viruses.
> http://promotions.yahoo.com/new_mail
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
> Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
> questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Tnx es 73
Dick W7ZR
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|