Towertalk
[Top] [All Lists]

[TowerTalk] Yaessu G-45A rotor connections

To: <towertalk@contesting.com>
Subject: [TowerTalk] Yaessu G-45A rotor connections
From: "Ed Laughery" <laughery@bellsouth.net>
Date: Sat, 8 May 2004 16:19:40 -0500
List-post: <mailto:towertalk@contesting.com>
Hello All

I have a Yaesu G-450A rotor/controller.  Looking at the molex connector on
the back of the controller- pin 1 is not present.  This is consistent with
the schematic, which also indicates that pin 1 is not used, however, the
wiring instructions indicate that all six pins should be connected betwenn
the molex plug and the round controller connector.  The only pin not
connected in the wiring diagram is pin 7 on the round rotor unit connector.
Am I analyzing this correctly?  This is a problem as I (for some stupid
reason) can't find the molex plug - I have pins/sockets but the plug has
gone on vacation.  So the only way I am deciding which pin is #1 (missing
pin) is thru the schematic where it appears that looking at the back of the
unit, the pin layout would be:

123
456

Is this correct?

Any help, confirmation, will be appreciated.

Ed AD5JV

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>