At 05:38 PM 9/28/02 -0700, you wrote:
Yes, they work great but why go to all that trouble marking them when all
you have to do is install one male and one female on the rotor and one male
and one female on the cable? That way, you will never get them mixed up!
And THANKS to all for your suggestions as to how my friend can repair his
cracked leg on his Rohn tower! I have printed them all out for him and I
will let you know the outcome.
Chuck KØTVD
>It is not a secret Phil. I have been using those trailer connectors for
>some time. They can be installed on a rotator, using pigtail leads, on
>the tower without soldering. Just use crimp connectors and tape them for
>insulation.. The critical junction between pins and wire is inside the
>molded rubber. I make a small notch in the rubber with a pocket knife on
>one pair to avoid ggetting them mixed up. 73, Dan, N5AR
|