Your response is typical of most I've received. I understand what you say.
In fact, there's a little bulge on one side of each piece of the bracket.
That, I figured out is so that it sits on the Z-brace. So you are right.
I wonder if I have a bent brace or something that allowed it to slip.
So I agree with you on this. Now my question is does this need to be fixed
or can I continue with it as is. I don't think it will slip any more.
73,
Jon
NA9D
on 9/18/02 5:55 AM, Mike Gilmer, N2MG at n2mg@eham.net wrote:
> That bracket sounds like a standard Rohn bracket. When installed (properly),
> it should nestle in the Z-braces and not have any room to slip down.
>
> Mike N2MG
>
> NA9D wrote:
>
>> One thing I noticed was that the guy bracket had literally slipped
>> downward slightly on one of the guys. I thought I had gotten it
>> tight, but apparently that was not the case.
-------------------------------------
Jon Ogden
NA9D (ex: KE9NA)
Life Member: ARRL, NRA
Member: AMSAT, DXCC
http://www.qsl.net/ke9na
"A life lived in fear is a life half lived."
|