My recommendation.
I just recently put up a second mast with a base mounted Tailtwister on
my flat deck on my roof. It's turning my once fixed 4 element
tribander. I installed a TB-5 above the rotor in a bracket I had made
which is attached to the elevator shaft housing, and then a second one
about 7' up near the top of the elevator.
I looked at wood, even the Brazil tough stuff, but since I'm
oceanfront, haven't had much luck with wood, so I bough two heavy duty
plastic cutting boards at Wal-Mart. The type that's made of a very
study, very hard plastic. Used two of them sandwiched together, drilled
for 2.25". They are about 3/4" thick and won't rot.
Works great!
Jon Hamlet, W4ZW
Casey Key Island, FL
"A little bit of Paradise in the Gulf of Mexico"
*My questions are:
*
*The mast is 2.5" OD. If I use a 2.5" hole saw to
*cut a hole in a board, will the wood swell and bind
*on the mast? It seems that the thicker the board,
*the more likely this is to be a problem. How thick
*should the board be?
*
*What diamter hole saw should I use? Is pressure treated
*lumber (like for outdoor decks) more or less likely
*to swell than, say, oak?
*
*The heavy-duty mast clamps actually bite into the
*heavy-walled aluminum mast. Still, perhaps due
*to temperature cycling, over time torsional play
*develops at the clamp-mast interface. The owner's
*manual says that the warranty is voided if I pin
*the mast. Of course, the rotor is out of warranty.
*Should I pin the mast? The Orion 2800 is turning
*5 elements on 20 with 2 Cushcraft shorty 40 elements
*on a 48' boom, plus 5 elements on 10 and 5 on 15 on
*a 38' boom.
*
*Thanks.
*
*Terry Zivney, N4TZ/9 _______________________________________________
*Self Supporting Towers, Wireless Weather Stations, see web
*site: http://www.mscomputer.com Call 888-333-9041 to place
*your order, mention you saw this ad and take an additional 5
*percent off any weather station price.
*_______________________________________________
*Towertalk mailing list
*Towertalk@contesting.com
*http://lists.contesting.com/mailman/listinfo/towertalk
*
|