----- Original Message -----
From: "Bill Otten" <res0958z@verizon.net>
To: <towertalk@contesting.com>; "Wes Cosand" <wz7i@arrl.net>
Sent: Saturday, April 20, 2002 12:41
Subject: Re: [Towertalk] Ground rods for Polyphaser clamps
I found the same thing happened to me.....so I cut a few strips of that
copper strap, goo'ed it with the copper goo and slid those in the
clamps...you could even wrap a bit of it around the ground rod I'd think to
'fatten' up the ground rod and then clamp it.
Bill KC9CS
----- Original Message -----
From: "Wes Cosand" <wz7i@arrl.net>
To: <towertalk@contesting.com>
Sent: Saturday, April 20, 2002 11:07 am
Subject: [Towertalk] Ground rods for Polyphaser clamps
> I have bought rods labeled 5/8" from both a consumer source and a
> commercial distributor and they are actually 9/16". The Polyphaser clamps
> for copper strips won't tighten up on the small rod. Anyone have a
suggestion?
>
> Wes WZ7I
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
Towertalk mailing list
Towertalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|