Look at the control box SCHEMATIC and you should then
be able to decide if it is safe to connect two in parallel.
The SAFE solution would be to use an 8 pole relay
to switch all lines between boxes.
Tom N4KG
On Wed, 27 Feb 2002 10:15:53 -0700 "Bruce Makas" <k1my@msn.com> writes:
> I would like to be able to turn a Tailtwister rotor from either of 2
> desks.
> Do I just wire the rotor controls in parallel? or I need to have an
> in line switch/relays?
>
> Is there a problem if both control units are powered on and I use
> one of
> them to turn the rotor? No damage to the other one and the indicator
> just follows?
>
> In addition (if that wasn't enough) does anyone sell T2X control
> boxes?
>
> Thanks, Bruce K1MY
>
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.
|