Here at PI4CC, we have just 1 controlbox and connect the controlbox with a few
feet of control line to a unique "male connector " . This connector can put in
a female wall mounted connector. On the wall mounted connectors we have the
control line to the rotor just in paralell. So we can pug the controbox at the
end, or on 2 other places. Why unique connectors? Just to be sure that the
controlbox for 20 is just for te 20 meter rotor. We have diferend kind of
rotors.
Peter
pb0aiu/pi4cc
Internet DX-cluster telnet://213.10.48.91
DX-cluster info http://www.pi4cc.nl/dxcluster
Bruce Makas wrote:
> I would like to be able to turn a Tailtwister rotor from either of 2 desks.
> Do I just wire the rotor controls in parallel? or I need to have an in line
> switch/relays?
>
> Is there a problem if both control units are powered on and I use one of
> them to turn the rotor? No damage to the other one and the indicator just
> follows?
>
> In addition (if that wasn't enough) does anyone sell T2X control boxes?
>
> Thanks, Bruce K1MY
>
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
|