I have the EZNEC 3.0 Files for the 40-2CD.
They are quite small (5KB and 9KB)but the reflector will not accept
attachments.
If anyone wants them, email me direct and I'll send them to you.
1. The single antenna
2. A stack at 67/134 feet.
Bill, N3RR
-----Original Message-----
From: owner-towertalk@contesting.com
[mailto:owner-towertalk@contesting.com]On Behalf Of Pete Smith
Sent: Wednesday, August 15, 2001 2:56 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] 402cd
At 06:24 PM 8/15/01 -0700, K3KO and Al Williams wrote:
>
>
>> Just for kicks I ran EZNEC for ............
>> I don't have a model for the 402CD. It would be interesting to
>> actually run such a model at the two heights.
>> 73 de Brian/K3KO
>
>Is there a reflector/forum somewhere for antenna modeling?
Yes, but it is almost quiescent -- antennaware@contesting.com.
If you know the location where the coils are installed and the other
dimensions, it should be fairly easy to add inductance until the antenna
comes into the right resonant frequency -- it won't simulate the capacity
hats, but it should be pretty close. Much easier than linear loading!
73, Pete N4ZR
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|