In a message dated 99-03-09 15:44:09 EST, rtudor@att.net writes:
<< I have a TH7 at 40 feet in a Ham IV. I am on the top of a hill at 2000 feet
ASL. I get a lot of high winds. The beam gets off the correct heading in the
strong winds.
My question - should I pin the mast to the rotator to stop the rotation? I
am not sure if I would cause a problem to the rotator. >>
My suggestion is to NOT pin it. The problem is that those wind forces
will find the next weak link in the system; in this case, either the ring gear
or brake. It's much easier and cheaper to realign the antenna occasionally
than swap/repair rotators.
The neck of the T2X has a hole that you can use to pin the mast if you
choose - the Ham IV does not. The Ham IV also uses smaller U-bolts so it
doesn't have the holding power that a T2X does.
What can you do? You could try some thin rubber material between the
mast and clamp although I think that some TowerTalkians have found this to be
unsatisfactory. One fix that I think did work was to apply some ScrewGrab
where the metal to metal contact is. ScrewGrab is a marvelous tool - it's got
little diamond-shaped material in suspension. It'll increase friction by 400%
and is VERY usefull for removing stripped screws and nuts. Just put a drop or
two where you need the friction and your problem will be solved. It's five
bucks for a tube from Champion Radio Products - http://www.championradio.com.
Cheers, Steve K7LXC
Champion Radio Products
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|