Alberto... I have a similar arrangement to the one you are planning. My two
thrust bearings only handle side to side movement and all the weight rests
on the Orion. The load is:
Mast: 150 lbs
20M monobander: 80 lbs
15M monobander: 60 lbs
10M monobander: 29 lbs
TOTAL: 319 lbs
While this is well under what you are proposing, the rotor turns well. Both
your system and mine are well under the vertical loading capacity of 1800
lbs mentioned in the Orion literature.
Your bigger problem will be what type of rotor shelf to use. I certainly
would NOT use the standard 45G rotor shelf for your installation. Even with
mine there is a noticable bow in the shelf... I wish I had used something else.
Larry WI5A
At 11:14 AM 12/25/98 +0100, you wrote:
>
>
>Hello to all,
>
>Since 3 years I'm a successful owner of this rotator (M2/ORION-2800) and
>now I
>need advice of the antenna gurus.
>
>Today my antenna system installed (mast + 1 yagi KLM 20M-5) weights 144
>pounds.
>I have installed two thrust bearing, but only support lateral forces, not
>vertical force (weight).
>
>I'm planning a new antenna system that weights (mast + 2 yagis) 660 pounds,
>with also two thrust bearing that support lateral forces, not vertical force
>(weight).
>
>My OR-2800 rotator can support this weight with no problems?.
>
>It is advisable install a one of the two trust-bearing to support the system
>weight to help the rotator?.
>
>Thank you in advance for your answer, and seasons greetings from Barcelona.
>
>Alberto Perello
>EA3CR
>
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|