Also, when you want to remove them the steel center pins tend to make the
drill bit walk and you end up with an egg shaped hole.
Bill, KB3AUG
Riverton,WV
On Tue, 25 Mar 1997 17:44:06 -0500 stan@ccsnet.com writes:
>Just make sure you use pop rivets with an aluminum center pin. The
>steel
>center pins will corrode out in a hurry when outsdie in the weather...
>
>
>Stan, WA1ECF Cape Cod, MA
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|