Towertalk
[Top] [All Lists]

Rotor leads

To: <towertalk@contesting.com>
Subject: Rotor leads
From: ve6jy@freenet.edmonton.ab.ca (Don Moman)
Date: Mon, 9 Dec 1996 20:15:11 -0700 (MST)
Doesn't cut it here, especially in winter. You haven't the -40C to contend
with so it might work.  At the very least, I install a 6 vac filament xfmr
in the controller cabinet to boost the ac for the longer runs. At the
most, I install a "repeater" box at the bottom of the tower - a home brew
xfmr and relay system, transparent to the user - it just senses the AC on
the various leads and the appropriate relays feed AC to the rotor. It's
T2X turning a 5 el 48' boom at 145', the tower is 300' or so away from the
shack.  Without the "repeater" operation is marginal - motor would turn IF
the brake would release, usually it won't. 

73 Don

VE6JY is Don Moman               email: ve6jy@freenet.edmonton.ab.ca 
Box 127 Lamont, Alberta
T0B 2R0  (403) 895-2925

On Tue, 10 Dec 1996, C. R. Crutchfield, K5BC wrote:

> I have a tower located 200' from the radio shack, the tower is 125' 
> tall.  My plans are to run the leads in conduit below ground and am 
> wondering how well the rotor (TailTwister) will perform.  By the time I 
> get through running the lead for the rotor it will be approx. 350'.  
> The lead I have is 2/12 gage and 6/14 gage.  I'm hoping the voltage drop 
> won't be that much but am not sure.  Any suggestions? 
> 
> 73's, Bob, K5BC
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 K7LXC@contesting.com
> Sponsored by Akorn Access, Inc & KM9P
> 


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>