Andy,
I just got a NCC-2 from a QRZ seller.
It has several optional modules.
My noise is mostly on the higher HF bands. I know the approximate location of
the source of the noise.
I installed a hi-impedance vertical element about 150ft away from the noise
source and it’s connected to my B input on NCC-2.
Input A in my main TX antenna which is a yagi at 120ft.
The NCC-2 works good at removing most of the noise. It does take some time to
get used to adjusting it.
I’ve only had it hooked up a couple weeks so still learning how to use. Feel
free to contact me privately if you would like.
73,
Steve NA5C
Sent from my mobile device
> On Dec 23, 2024, at 8:12 AM, Andree DL8LAS via Topband
> <topband@contesting.com> wrote:
>
> Hey,do any of you use an NCC-2 or NCC-1 for antenna phasing or noise
> reduction? Do you have any experiences and can give me information?
> 73 Andy DL8LAS
>
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|