Topband
[Top] [All Lists]

Re: Topband: Quarter wave sloper ?

To: "jim.thom jim.thom@telus.net" <jim.thom@telus.net>
Subject: Re: Topband: Quarter wave sloper ?
From: Felipe J. Hernández <np4zet@gmail.com>
Date: Sat, 27 Jul 2024 17:57:55 -0400
List-post: <mailto:topband@contesting.com>
In my case I have a 1:1 balun one leg to the antenna and the other to the
tower, it’s simple and it works

On Sat, Jul 27, 2024 at 4:37 PM jim.thom jim.thom@telus.net <
jim.thom@telus.net> wrote:

> Tnx for the quick response.
>
> Is a CM choke required at the feedpoint ?
> If  I can't fit the entire required length of wire,(I think I can get aprx
> 110-120')  can I insert a small coil at the feedpoint ?  Perhaps relay
> switched, to obtain 2 x segments.
> I'm toying with the idea of using the 75m rotary dipole at the top of the
> mast as a possible RX ant for 160m....might be worth a try at least. The CM
> choke at the 75m rotary dipole has 10.5 k Z on 160m.   I have zero room for
> dedicated 160m RX ants. My corner lot is only 89' wide x 115' deep.
> Monster house next door.  I have a power line running down the side street,
> on my side.
>
> Jim  VE7RF
>
> On Sat, Jul 27, 2024 at 12:50 PM Felipe J. Hernández <np4zet@gmail.com>
> wrote:
>
>> Yes, is a great performer, don’t waste your time with inv v or sloping
>> dipoles, is a little trickier to tune but it’s a fantastic radiator.
>>
>> Felipe
>> Np4z
>>
>> On Sat, Jul 27, 2024 at 3:48 PM jim.thom jim.thom@telus.net <
>> jim.thom@telus.net> wrote:
>>
>>> Has anyone had success with a 160m,  1/4 wave sloper....hanging off a 90'
>>> tower, with a 40m yagi just above the top of the tower ?
>>> _________________
>>> Searchable Archives: http://www.contesting.com/_topband - Topband
>>> Reflector
>>>
>>
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
<Prev in Thread] Current Thread [Next in Thread>