Hi Ron.
I got on about when you worked DF2PY. I thought Wolf was rather loud at
the time. Earlier, I had tried calling OK1DOT but he could barely copy
me and fractured my call. I did not see any change in noise level, but I
was not sitting there and closely listening 100% of the time. I was not
listening at 0110 UT. I did work OK1CF at 22:00 UT and he was not very
strong and I was 449 with him. I used to live in Germany quite near
where Wolf is. I would drive by his QTH in Ingleheim when I went to
Wiesbaden. It is always great to work him.
73
Dave K1WHS
On 1/26/2023 10:33 PM, Ron Spencer via Topband wrote:
Band started out great here in NC. Very quiet. Called CQ and lots of strong EU
rbn spots which hasn't happened in a long time. OK1CF was quite loud and,
around 0046 worked him with 5W. Pretty amazing.
Then, around 0110 or so, something happened. The noise floor jumped 10 or 15dB
across the whole band. A few minutes later it dropped again but still a little
higher than before. And signals from EU were down. Karel, OK1CF, must have
dropped at least 10dB, maybe more. Listening now, at 0300, Wolf, DF2PY is
pretty good copy as are a few other EU signals. But band is not as good as it
was earlier. CQing brought just one EU rbn spot at 2dB vs 10 to 15 spots around
2330. Hoping band recovers quickly from whatever caused the issue. Sure was fun
earlier!
73
Ron
N4XD
Sent using https://www.zoho.com/mail/
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|