Sam,
P.S. I only run 100 watts, but these relays might be adequate for you????
I'm sure there will be better options that others will mention.
Don (wd8dsb)
On Thu, Dec 6, 2018 at 3:10 PM Don Kirk <wd8dsb@gmail.com> wrote:
> Hi Sam,
>
> In my remote base loading box I used relays AD5X specified in one of his
> articles on a matching network. They might be over kill for your project
> as they are 3PDT relays. The relays are Deltrol Controls part number
> 21014-81.
> They come in various mounting configurations:
>
> - 375F: Flange cover
> - 375TM: Top mount cover
> - 375P: Printed circuit terminals
>
> I use the 375M version.
>
> You might look and see what other relays Deltrol Controls offers.
>
> Just FYI,
> Don (wd8dsb)
>
>
>
>
>
> On Thu, Dec 6, 2018 at 1:36 PM Sam Josuweit <samjos@epix.net> wrote:
>
>> No
>>
>>
>>
>> From: Mike Waters [mailto:mikewate@gmail.com]
>> Sent: Thursday, December 06, 2018 12:02 PM
>> To: Sam Josuweit
>> Cc: topband
>> Subject: Re: Topband: Recomended Relays
>>
>>
>>
>> You're not planning on hot-switching it, are you? That's hard on
>> amplifiers. :-)
>>
>>
>>
>> 73, Mike
>>
>> www.w0btu.com
>>
>> On Thu, Dec 6, 2018, 10:48 AM Sam Josuweit <samjos@epix.net> wrote:
>>
>> Can anyone recommend a good general use relay for antenna switching in the
>> 800-1000w power range? I know using power relays can be a roll of the
>> dice.
>>
>> According to modeling peak voltages should be less than 450V.
>>
>>
>>
>> Thanks
>>
>> Sam(N3XZ)
>>
>>
>>
>> _________________
>> Searchable Archives: http://www.contesting.com/_topband - Topband
>> Reflector
>>
>> _________________
>> Searchable Archives: http://www.contesting.com/_topband - Topband
>> Reflector
>>
>
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|