Topband
[Top] [All Lists]

Re: Topband: Shunt Feed help

To: "bob burton" <n4pqx@yahoo.com>, <topband@contesting.com>
Subject: Re: Topband: Shunt Feed help
From: "Marc Wullaert ON4MA" <marc.wullaert3@telenet.be>
Date: Tue, 10 Oct 2017 19:43:00 +0200
List-post: <mailto:topband@contesting.com>
Hi BoB,

be careful with the c31xr as the 20m reflector is on the far end. maximum voltage present there and mine burned down at the isolator while my freestanding tower (24m) with c31xr and 5m higher a 40cd2 40m 2element beam
where shuntfed on 160m.

Best way is to ground the element or look for a better isolator

73

Marc ON4MA
https://www.facebook.com/marc.wullaert.5
----- Original Message ----- From: "bob burton via Topband" <topband@contesting.com>
To: <topband@contesting.com>
Sent: Tuesday, October 10, 2017 2:22 PM
Subject: Topband: Shunt Feed help


Looking for some shunt feed wisdom from the list. Trying to shunt feed 25G tower ( 8-10ft sticks, 8ft flat top, base 18" out of the ground = total tower 89.5 ft) has a F12 C31XR just above the thrust bearing (@90ft) with 6ft 2" mast above the tribander with a F12 D140 dipole (@96ft). Based on various archive reading I can't get a good sense of how much top loading I may have (some say only the boom, others say much more). That said I've first tried a cage wire ( four 14ga wires spaced 6" apart) all the way at the top of the tower spaced about 2ft out. Trying to dip this with an Autek RF-1 yielded about 1.15 Mhz which didn't seem right. Cage was taken down and tried just a single wire at a lower tap height of 60ft. Strangely enough I get about the same frequency but the Z dropped. Moving farther down to 50ft again about the same frequency but again Z dropped. I'm assuming the frequency readings are completely off and I'm getting overload from nearby AM broadcast as I am surrounded by them. I'm unsure now if I should continue trying tap points farther down the tower just looking for the best Z or use some other approach. If anyone has experience with how much top loading a C31XR could represent I could use the graphs in ON4UNs book to perhaps get close, but I'm unsure what the loading looks like and found no real answers searching the archives. Any help appreciated to help eliminate many more trips on the tower looking for the nearest 50 ohm spot. Tnx 73's Bob - N4PQX
_________________
Topband Reflector Archives - http://www.contesting.com/_topband


---
Dit e-mailbericht is gecontroleerd op virussen met Avast antivirussoftware.
https://www.avast.com/antivirus

_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>