Hello JC,
Thanks for your answer.
I just ordered a few 2631803802 and 5943003801 from mouser.
With these ferrites I ask the same question, should I put the choke close
to the 9:1 Balun or near the switching box and how many turns? some bevs
have the feed point at +- 60m away from the switching box.
73's Filipe Lopes
CT1ILT - CR6K
F4VPX - TM3M
2015-10-12 15:40 GMT+02:00 JC <n4is@comcast.net>:
> Hi Filipe
>
> Zero , you should use material #31 or #77 , The core you have is not good
> for low bands.
>
> JC
> N4IS
> -----Original Message-----
> From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Filipe
> Lopes
> Sent: Monday, October 12, 2015 8:46 AM
> To: topBand <topband@contesting.com>
> Subject: Topband: Commond mode choke for Beverage
>
> Hi guys,
>
> I am about to add a common mode choke to isolate the antenna from its
> feedline to each of my beverages and I only have FT240-61 ferrites. My
> question is how many turns should I do on the ferrite using RG58 (all my
> bevs are fed with RG58). Also should I put the choke near the 9:1 balun or
> near my bev switching box?
>
> Thanks in advance.
>
> 73's Filipe Lopes
> CT1ILT - CR6K
> F4VPX - TM3M
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|