Re: Topband: Passive Receive Antenna Splitter

["Carl" <km1h@jeremy.mv.com>]

All the TV splitters Ive taken apart are pure autotransformers with poor 
isolation. A VNA will show them deterioating and doing very little at 160M.
It is simple enough to wind transformers for a splitter using 1/2" type 43 
toroids. See this link that gives an excellent discussion and also shows the 
cheap way of doing it and the better way. Guess what is used in consumer 
grade CATV versions.
http://www.minicircuits.com/app/AN10-006.pdf

Both versions have been in handbooks for decades and I first started using 
them with Beverages in the mid 80's. Ive also used them as combiners and 
connecting various combinations of 2 Beverages with some very beneficial 
performance at times. Port to port isolation was very important to me.
There are also several other on line versions, good and bad, if you do a 
Goggle for "how to make a 2 way 50 ohm splitter"
Carl
KM1H



----- Original Message ----- 
From: "Charlie Cunningham" <charlie-cunningham@nc.rr.com>
To: <garyk9gs@wi.rr.com>; "'Topband Mailing List'" <topband@contesting.com>
Sent: Thursday, March 13, 2014 9:41 PM
Subject: Re: Topband: Passive Receive Antenna Splitter


> One word of caution, Gary, if the CATV splitter is a transformer type,
> rather than resistive it may of have enough low-frequency response for 160
> m!  Check around with RS and your local electronics stores for 50 ohm 
> 2-way
> splitters. Those are generally resistive and have frequency response from 
> DC
> up to a GHz or so.  Some of the TV stuff is transformer coupled.
>
> 73,
> Charlie, K4OTV
>
> -----Original Message-----
> From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Gary 
> K9GS
> Sent: Thursday, March 13, 2014 9:14 PM
> To: Topband Mailing List
> Subject: Topband: Passive Receive Antenna Splitter
>
> Can anyone point me to a design for a splitter for sharing a Beverage
> antenna between two receivers?  This is for Field Day so these are not
> optimized Beverages by any means.
>
> Just want to allow the 80/40M stations to share antennas.  Nothing fancy.
>
> My thoughts are to just use a CATV "2-Way" splitter at the output of the
> Beverage matching transformer and run separate feed-lines to each radio.
> I'm pretty sure these things work down to 1 MHz but have not measured 
> them.
> I can use the pre-amp in the radio (K3) to compensate for the loss.
>
> Thoughts?
>
> --
>
>
> 73,
>
> Gary K9GS
>
> Greater Milwaukee DX Association: http://www.gmdxa.org Society of Midwest
> Contesters: http://www.w9smc.com
> CW Ops #1032   http://www.cwops.org
>
> ************************************************
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2014.0.4336 / Virus Database: 3722/7192 - Release Date: 03/13/14
_________________
Topband Reflector Archives - http://www.contesting.com/_topband