That is certainly possible, Frank - I've been using Ideal compression
connectors from Home Depot. I have not had any reliability problems
with them at all - they are just a pita to connect and disconnect.
If a BNC is wrapped with Scotch 2242, over-wrapped with Scotch 88+, and
not submerged, shouldn't that be adequate?
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
On 11/14/2013 7:31 AM, donovanf@starpower.net wrote:
Hi Pete,
I wonder why you've decided to switch to BNCs? They have their own issues and
they've completely unsuitable for outdoor use.
I wonder if perhaps you've been using poor quality F connectors?
73
Frank
W3LPL
----- Original Message -----
From: Pete Smith N4ZR <n4zr@contesting.com>
To: Topband@contesting.com
Sent: Thu, 14 Nov 2013 07:24:59 -0500 (EST)
Subject: Topband: Replacing F Connectors with BNCs
I have finally decided to go through my RX antenna systems and replace
all the F connectors with BNCs. My coax is all RG-6 Quad shield. I
would like to find an all-crimp BNC male solution, or failing that, one
that only requires soldering the center conductor.
Any advice on which connectors would be best, or which to stay away from?
_________________
Topband Reflector
|