Topband
[Top] [All Lists]

Re: Topband: Raised radial question from NH

To: "'Jim F.'" <j_fitton@yahoo.com>, "'top Band'" <topband@contesting.com>, "'Jim Fitton'" <w1fmr@arrl.net>
Subject: Re: Topband: Raised radial question from NH
From: "Charlie Cunningham" <charlie-cunningham@nc.rr.com>
Date: Sat, 19 Oct 2013 12:37:17 -0400
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Hi, Jim

In my experience, the answer is "no" to both questions - although a full
size inverted L , while being a very effective transmit antenna can be a
really noisy receive antenna. Can you go out in the woods and hang a flag,
pennant or KAZ terminated loop for a receive antenna? Helped me a LOT o RX!

Good luck!

73,
Charlie

-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Jim F.
Sent: Saturday, October 19, 2013 12:28 PM
To: top Band; Jim Fitton
Subject: Topband: Raised radial question from NH

Nothing heard this morning in NH at 1530Z.

Am in a condo environment where invisibility is a factor.
Antenna is an Inverted L  fed through a series capacitor with two #22
ga. raised radials 136' long ~ 10 feet high running through the woods
which have stayed up 2 days so far.

One question :

Do you think that thin radials could cause an increase in receiver noise ?

Another question :

The 50 ohm feedline line is 25' long connected directly to the rig.
Is isolation needed to preserve the effectiveness of raised radials ?
If so, what would the isolation consist of ?

73

Jim / W1FMR / QRP
_________________
Topband Reflector

_________________
Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>