Re: Topband: Topband Digest, Vol 129, Issue 23

[Grant Saviers <grants2@pacbell.net>]

Try a large transformer shop.  5kw and up transformers often use it.  
I've bought round magnet wire from temcoindustrialpower.com, but don't 
see rectangular wire on the web site, so give them a call for a link.
Grant KZ1W

On 9/15/2013 9:04 PM, n0tt1@juno.com wrote:
> I've just used strips of sheet copper cut with
> snips for "flat" wire.  I purchased a sheet from a
> Hobby Lobby store.  Their ads usually include a
> 20% off coupon good for just about any
> one item at their stores.
>
> 73,
> Charlie, N0TT
>   
> On Mon, 16 Sep 2013 01:39:46 +0000 (UTC) wa3mej@comcast.net writes:
> > I know this may be a little off topic BUT.... I am looking for some
> > flat wired to wind an edge wound inductor. I am guessing that it
> > needs to be something like an eight of an inch on the narrow side by
> > maybe three eights of in inch on the long or flat side. This will
> > allow my roller wheel to ride on the inside of the inductor to
> > change inductance.
> >
> > Now for the rub.  I cant find anyone that makes wire like this.  I
> > know it is made because others have made inductors using this kind
> > of wire. Oh and it has to be silver plated if possible.
> >
> > These coils are to be part of a balanced tuner and yes I know I can
> > purchase coils but I want consistency since I am going to build
> > several of these units.
> >
> > Any and all help appreciated.
> >
> > Thanks  Jim WA3MEJ
> >
> >
> > http://www.qsl.net/wa3mej/index.htm
> > _________________
> > Topband Reflector
>   
>
> _________________
> Topband Reflector
_________________
Topband Reflector