I'm having a repeated weird problem with compression F connectors on
quad-shield RG6. When I connect a short length (say 4 feet) of cable to
my MFJ-259B, I would expect R>650. Instead, when I wiggle the coax,
occasionally I see the display change to R=0 and X= several hundred ohms
at 1.8 MHz. This makes no sense to me - the R implies ashort, but where's
all the X coming from?
R doesn't come from a short, it comes from no loss resistance, or more
correctly very low loss resistance.
It sounds like the connector you have is not contacting all the shields.
This is typical for mismatched connectors and cable, or improperly
manufactured cables. It could be somewhere else also, but I've seen this
before with quad shield. That's why I avoid it.
The problem seems to vary with the same
connector and different PL-259 to F adapters, which makes me wonder what
might be happening inside the adapters, but I can't imagine anything
producing this result. I have also been unsuccessful in detecting a short
using a simple DC multimeter.
Remember how RF current flows. It flows on the outside of cables, unless it
has a connection path to the inner shield. If you have cable with Mylar on
the inside of one or more shield layers, and a connector that only contacts
the outside of the outer shield, the inner shields that carry nearly all of
the desired transmission line currents will be insulated and isolated from
the shield at the connector. Every shield has to be contacted at the
connector, or at least the inner shield does.
This might not be it, but it is a common issue with quad shield. Dual shield
is much more forgiving of connectors. You'll never detect the leakage in
dual shield in outside runs. If you have nasty common mode problems, a
thicker shield will help. It is also just as simple to add a few dozen or
few hundred ohms of common mode choking to regular dual shield cables and
knock down CM ingress to levels that cannot be noticed.
I;'m wondering if I should go through my RX antennas and replace all the F
connectors and particularly the F to 259 adapters with something else, but
what? BNCs?
BNC's are worse yet, as a general rule. They rely on spring pressure for the
shield path. Look into a type match error between the cable you have and the
connectors, or a connector installation error.
73 Tom
All good topband ops know fine whiskey is a daylight beverage.
_________________
Topband Reflector
|