Topband
[Top] [All Lists]

Re: Topband: Ground conductivity, permittivity measurement

To: <topband@contesting.com>
Subject: Re: Topband: Ground conductivity, permittivity measurement
From: "Richard Fry" <rfry@adams.net>
Reply-to: Richard Fry <rfry@adams.net>
Date: Wed, 3 Oct 2012 09:03:00 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Cristi YO3FFF wrote:

From Terman (as Richard Fry mentioned): http://i62.photobucket.com/albums/h85/rfry-100/TermanFig55.jpg

First hop distance on E layer reflection for given angles is:
20 degrees = 300miles, 30 degrees = 200miles
______________

But note that Terman shows much longer 1st-hop skywave paths at elevation angles below three degrees -- where a NEC far-field pattern of a vertical monopole over real earth shows very low relative field from a vertical monopole.

A NEC far-field pattern of a vertical monopole over real earth also shows zero field in the horizontal plane, but clearly that is incorrect. If it WAS correct, then AM broadcast stations would have zero daytime coverage by their surface (ground) wave. Yet a 50 kW station on a low frequency can provide useful groundwave service beyond 200 miles from their antenna site, in many cases.

The surface wave MUST be considered when evaluating skywave performance of a monopole, because that surface wave contains significant radiation at low elevation angles capable of producing skywave coverage.

This was shown clearly in the NEC4.2 plot posted by Paul Christensen earlier in this thread, at http://72.52.250.47/images/160m.jpg , and also in my link http://i62.photobucket.com/albums/h85/rfry-100/Measured_vs_NEC2D_Fields2.jpg

R. Fry
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK

<Prev in Thread] Current Thread [Next in Thread>