Hi Mike,
I have not tried to run two Bevs like that, but I have tried to run one
close to a wire fence. The best F/B I achieved was about 8 dB. I would
think that the two scenarios would be very similar.
73, Greg ZL3IX
On 2012-05-23 06:20 a.m., rfman45 wrote:
>
>
>
> For various reasons I am considering two single, parallel but 180deg
> opposing direction beverages on the same supports rather than a single
> switchable bidirectional beverage. The bevs would be separated by 12 to 18
> inches or so. I've read that parallel bevs present performance degradation
> issues but has anyone had any experience with this type of setup versus the
> traditional bidirectional beverage? Thanks for reading this and for any
> thoughts you could offer.
> Mike W2LO
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|