I built it in one evening using two pieces of scrap 1x3 lumber for
spreaders. I pounded in four large wire staples to hold the wire to the
spreaders and threaded both loops through them. The five wire and one
wire pickup loop are not separated. I used a variable cap of roughly
150-200PF to resonate the 5 wire loop. I fed the pickup loop directly
with RG-58 coax. No matching transformer. The loop is roughly 32 inches
square. I tune the cap for maximum noise for the desired frequency.
The loop is tunable from about 1600 - 1850 KHZ.
I modeled my loop after the following designs for unshielded loops.
http://www.i1wqrlinkradio.com/antype/ch9/chiave1183.htm
http://members.verizon.net/~vze24qhw/loop.html
On Tue, 2012-04-10 at 08:49 -0400, joe wrote:
> I am experimenting with a small one meter square loop. It is 5 turns of
> #14 wire with a one turn pickup loop. Feeding the pickup loop directly
> with 50 ohm coax. Using air variable cap to resonate the 5 turn loop.
> I have it setup in my basement on a tripod with small TV rotator and it
> works amazingly well. I can null stations about 3-4 S units with it and
> it is about 4 S units (24 DB) quieter than my inverted L. I also have a
> short 140 foot BOG and the loop performs nearly the same with the added
> ability null out noise sources. I plan to move it outside and take some
> more measurements. I'm pretty impressed so far. -Joe KB3KJS
>
>
>
>
> On Mon, 2012-04-09 at 17:17 -0700, Jim WA9YSD wrote:
> > How well does this antenna perform in a City environment like mine on top
> > of a 50 foot tower?
> >
> > Stay on course, fight a good fight, and keep the faith. Jim K9TF/WA9YSD
> > _______________________________________________
> > UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|