My TS-940 has the same setup but not the TS-950SD and many other rigs. I use
a toggle switch an high isolation DIP relay to do the control, under $5 in
parts.
Carl
KM1H
----- Original Message -----
From: "Rik van Riel" <riel@surriel.com>
To: <topband@contesting.com>
Sent: Thursday, April 21, 2011 2:52 PM
Subject: Re: Topband: What are folks using for a T/R relay in the shack, to
switch between beverage and xmit antennas?
> On 04/21/2011 10:08 AM, Mark Lunday wrote:
>> I see some stuff out there from DX Engineering, but before I buy I wanted
>> to
>> check with others. Thanks
>
> On my old TS-930, I plan to use the transverter (XVTR)
> plug on the back of the radio to feed in the RX antenna
> separately.
>
> It has a place where the TX antenna's received signal
> goes out, and gets back looped in to the radio's
> receiver ... or not, you can intercept and change it :)
>
> --
> All rights reversed.
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|