that makes a dipole not a beverage. A Beverage MUST be fed at the end. It
is a traveling wave antenna, not a conventional coupling antenna like a
dipole
If you must, build the feedpoint at the end and run the coax cable back
along the ground under the beverage- bury it a few inches if you can and
add a ground post where you make the turn to go to the shack - all an
attempt to decouple the shield of the coax from being part of the antenna
Robin, WA6CDR
----- Original Message -----
From: "DF3KV" <df3kv@t-online.de>
To: <topband@contesting.com>
Sent: Friday, July 09, 2010 14:50
Subject: Re: Topband: Fw: The 500 Foot Beverage
> How do they behave if the RX connections are at the centre of the run?
>
> 73
> Peter
>
> -----Original Message-----
> From: topband-bounces@contesting.com
> [mailto:topband-bounces@contesting.com]
> On Behalf Of Robin
> Sent: Freitag, 9. Juli 2010 21:34
> To: Dave Harmon; Topband@contesting.com
> Subject: Re: Topband: Fw: The 500 Foot Beverage
>
> The root beverage design at VP6DX was the DXE reversible hardware & 450
> ohm
> ladder line. Worked flawlessly. I have used the DXE hardware in other
> applications and its the closest Ive found to playing as advertised.
> Beverage lengths between 500 and 1200 ft at VP6DX. the phased 800 footers
> toward Eu played very nicely.
>
> Consider - the local background noise at VP6DX is as close to zero as it
> gets. All noise was propagated noise. The beverages DRASTICALLY out
> performed listening on the TX Omni. This means ALL the work is being
> done
> by directivity- (in both planes), and the beverages clearly have the
> directivity.
>
> Bottom line rule. ANY beverage is better than no beverage. Trees, bends,
> short, long, single, double, Build it and use it.
>
> I really don't like the term reversible. The antenna array is NOT
> reversible, it is a two direction antenna array - not bi directional- it
> is
> two directive arrays in one assembly. How you use it is up to you- two
> feedlines and hook the two lines to the two receivers in a K-3 and you
> have
> long and short path at the same time, and there are MANY other useful
> combinations.
>
> Robin, WA6CDR
> ----- Original Message -----
> From: "Dave Harmon" <k6xyz@sbcglobal.net>
> To: <Topband@contesting.com>
> Sent: Thursday, July 08, 2010 21:04
> Subject: Re: Topband: Fw: The 500 Foot Beverage
>
>
>> Has anyone tried the DX Engineering reversible 2 wire Beverage?
>> I think this is a W8JI design.
>> Yes, I know they are expensive and I can make one a lot cheaper but if
>> anyone can compare actual performance I would like to hear about it.
>> Thanks....
>>
>> Regards
>>
>> Dave Harmon
>> K6XYZ[at]sbcglobal[dot]net
>>
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|