Pete - my average noise floor, when measured using the same rig with a 250
Hz bandwidth and a sampling rate of 48 KHz is:
-128 dBm on 8 circle Vertical Array
-125 dBm on Beverages
-105 dBm on my inverted vee
-100 dBm and on shunt fed tower
73 Joel W5ZN
-----Original Message-----
From: Pete Parisetti [mailto:hb9dsu@gmail.com]
Sent: Sunday, October 18, 2009 9:30 AM
To: topband@contesting.com
Subject: Topband: noise floor
Hello everybody from a newcomer to the list.
I have a question. I would like to understand if my suburban location is
significantly more noisy than others or not. To do so, it is handy to have
the noise floor measured in dBm - something I can do with my SDR 5000a. The
value is around -82 dBm in conditions which I would call "bad" and around
-90 when "good", measured with the TX antenna (inverted L, 17m vertical/23
horizontal).
Would anybody else with the same rig (or similar) share their numbers?
Thank you very much in advance and 73.
Pete
___________________________
Pete Parisetti MM0TWX - HB9DSU
for music, ham radio and more
visit http://www.hb9dsu.com
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|