EZNEC 5. Regardless of my inability to model I would be interested in any
practical solutions that have already been tried and known to work.
Thanks 73Bob
--- On Sat, 9/26/09, W2XJ <w2xj@nyc.rr.com> wrote:
From: W2XJ <w2xj@nyc.rr.com>
Subject: Re: Topband: electrically shortening a tall grounded tower
To: "Bob Kupps" <n6bk@yahoo.com>, "topband" <topband@contesting.com>
Date: Saturday, September 26, 2009, 11:56 AM
What software are you using? Often modeling software can not handle cages.
On 9/25/09 11:50 PM, "Bob Kupps" <n6bk@yahoo.com> wrote:
> Hi
> Is there any effective way to electrically shorten a tall grounded tower to
> 1/4 wave? I tried modeling a 1/4 wave cage surrounding the tower but it still
> shows a lot of current in the protruding section with resulting high angle
> radiation. Then I tried modeling a 1/4 wave stub above the cage grounded at
> the top to the central tower which appeared to turn it into a dipole and still
> significant current above the stub. I was also thinking of using an external
> parallel resonant trap/choke but would this actually work when situated at a
> zero current point at the far end of a 1/4 wave monopole?
> Thanks and 73 Bob N6BK/HS0ZIA
>
>
>
> _______________________________________________
> Topband mailing list
> Topband@contesting.com
> http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|