Topband
[Top] [All Lists]

Topband: Re: Number of Radials/Elevated vs Grounded

To: <topband@contesting.com>
Subject: Topband: Re: Number of Radials/Elevated vs Grounded
From: dxer10@hotmail.com (Duncan Cameron)
Date: Fri, 15 Mar 2002 14:43:24
Hello-
I am very interested in this topic. I have a "third wavelength" inverted 
'L',(total length of 175 feet with 65 feet in the vertical section) whose 
feedpoint is 7 feet above ground with 4 symetrical elevated radials 1/4 
wavelength long. Directly underneath this feedpoint, I have a ground pipe 
(copper water tubing) and a separate radial system, lying just below the 
surface. This "ground reflector" consists of 20 1/4 wavelength radials and 2 
1/2 wavelength radials.  The longer radials run approximately under the 
horizontal radiator of the 'L'.  The ground condition here is rocky gravel 
and quite dry.  I plan on adding 4 more elevated radials. All of the 
elevated radials are #18AWG insulated wire. The ground radials are attached 
to the ground rod using copper "pipe hangers" that are clamped to the ground 
pipe and holes in the strap are used to attach the radials. (they are silver 
soldered to the strap)
My experience in putting up this antenna with just the 4 elevated radials 
indicates that the whole system improves significantly with the addition of 
the ground radials. Signals are typically 2 to 3 S units better with the 
"ground mirror".
I am sure with more ground radials, the results would be even better.
Scott

_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp.


<Prev in Thread] Current Thread [Next in Thread>
  • Topband: Re: Number of Radials/Elevated vs Grounded, Duncan Cameron <=