I wrote:
> > Does anyone know the typical noise figure of the FT-1000D on
> > 160 meters when it in the high gain (versus AIP position)?
Well, nobody answered my email, so I looked up the MDS (minimum discernable
signal) specs from the test reports on the ARRL website. I am not sure of
the proper convention for determining MDS, so I assumed that MDS = 0 dB S/N
ratio and worked backwards to determine the receiver's noise figure. With a
measured MDS of -138dBm thru 250 Hz filters (pre-amp on), I got a noise
figure of 12 dB (-138 dBm - [-174 dB/Hz + 10*log(250)]).
I needed to know, as I am trying to figure out if an external pre-amp will
offer any advantage when used with the flag antennas my friend Bob and I are
going to install at the local club station.
Hope this is helpful.
Mike, W4EF
--
FAQ on WWW: http://www.contesting.com/FAQ/topband
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|